Attaching Equipment

BENDER / BOOTER

ETCO's bender/booter is designed to boot and bend a combination of our CB2, CB3, AB16, CB8, AB15, and AB20 boots, along with DT200LB, DT207LB, DT200B, DT250B, DT257B, SP19 and DT7B terminals. The ETCO bender/booter is a table-mounted unit that measured 24" wide, 18" deep. It operated when foot-pedal system is depressed, then pulls the treminal through the heated and lubricated boot; bends the terminal to desired angle and returns to the start position. The units operated on a 115v and 50 to 60 lbs. psi filtered air.

[Applicators not shown to scale and some guards not shown.]